Omnibus F4 Nano V6飞控 BEC +OSD +Baro 支持2-6s锂电8针四合一电调接口

¥298.00

- +
服务承诺

Omnibus F4 Nano V6飞控 BEC +OSD +Baro 支持2-6s锂电8针四合一电调接口
厂商: Airbot
编号: AB80100

产品概述:
5x UARTs
通过四合一接口支持电调遥测功能
5V/2A BEC输出
支持2-6S锂电
固件请使用V2版驱动, 设置CLI, set gyro_to_use = SECOND
新款V6无刷动力AIO航拍无人机飞控
With Support ending for F1 processors, F3 become the bottom wrung, but don't worry, this little board features an F4 MCU.
Its Betaflight OSD is connected over SPI in DMA, and is designed on the current proposed architecture for betaflight.
It will show you any and all data you want on your FPV feed and you can change settings including tune your PIDs without taking your goggles off!
The board also features an MPU6000 gyro connected over SPI for fast, accurate, low noise gyro data and can support 2-6s direct input.
请注意:
如果想使用该飞控配合同品牌四叶一电调,仅需另购8针排线(选购件/不含)

产品特点:
01. 2-6s直接供电(adaptor to connect to Wave 4in1 ESC providing power and ESC signal connection (note Wave is 2-4s)
02. MPU6000 gyro connected by SPI for low noise, clean, high frequency gyro samples
03. BMP280 Barrometer to enable altitude hold
04. Betaflight OSD
05. Onboard voltage sensor
06. On board 5v regulator, components rated to 2A - recomended 1A max to prevent heat build up)
07. Built in L-C filter to provide clean power to FPV kit
08. STM32 F405 MCU running betaflight 3.2
09. pin headers for SBUS/PPM input
10. output for 4电机输出JST-SH 1.0 8针 链接道本厂4合1电调 (8针4合1排线供选购)
11. 尺寸25x25mm (20x20mm M3 固定孔)

发表评论

注意 评论内容不支持HTML代码!
差评 好评
凡在大道优品购买商品,若存在质量问题,本商城支持退换货服务并承担来回邮费!

标签 Omnibus F4 Nano V6飞控 BEC +OSD +Baro 支持2-6s锂电8针四合一电调接口